Dosbarth I+ Dosbarth II / Math 1+ Dyfais Diogelu Ymchwydd Math 2 (SPD)

Prosurge’s Type 1 + Type 2 Dyfeisiau Amddiffyn Ymchwydd (SPDs) are designed to discharge high current surges without any destruction of the installation.

This surge protective device is characterized by its capacity to withstand impulse current with 10/350µs waveform which simulates direct impact coming from a natural lightning current.

Prosurge Type 1 + Type 2 (class I + Class II)  SPDs are placed at the entrance point of the installation, in the main distribution board for a global protection of this installation.

Prosurge also provides Class I + Class II, Type 1 + Type 2 SPD with different technology of spark gap technology, VT technology and MOV technology.

Technoleg MOV – 25kA 10/350 – TUV Ardystiedig

Technoleg Bwlch Spark wedi'i Encapsulated

Class II / Type 2 (also tested to class I + Class II, T1 +T2) Surge Protection Device (SPD)

Prosurge Type 2 Dyfeisiau Amddiffyn Ymchwydd (SPDs) are also tested to Type 1 + Type 2 with impulse current 10/350µs.

It is designed to discharge high current surges without any destruction of the installation. This surge protective device is characterized by its capacity to withstand impulse current with 10/350µs waveform which simulates direct impact coming from a natural lightning current. Prosurge Type 2 SPD (also T1 + T2) SPDs are placed at the entrance point of the installation, in the main distribution board for a global protection of this installation.

Rating:

• Uc range: 75Vac to 750Vac
• Imax: 50kA 8/20
• Iimp: 7.5kA 10/350
• Various SPD configuration: 1+1, 2+0, 3+0, 3+1 SPD

Dyfais Amddiffyn Dosbarth II / Math 2 Arlliw (SPD)

Prosurge Class II/T2 surge protective device is designed for low-voltage power supply system protection against surges at the boundaries from lightning protection zone 1-2 and higher.

• KEMA certified Class II/T2 SPD per IEC/EN 61643-11.
• UL certified Type 1ca SPD per UL1449 5^th edition (pass SCCR test 200kArms)
• Capasiti rhyddhau presennol yn codi hyd at 40kA 8 / 20μs
• High reliability due to global patented thermally protected MOV with reliable arc-extinguish (TPAE) technology.
• Modiwl ychwanegadwy ar gyfer ailosod hawdd
• Degradation indication and remote signal contact.
• Comply with IEC/EN 61643-11, UL1449 5^th, CSA C22.2 etc standards

Dyfais Amddiffyn Ymchwydd Dosbarth III / Math 3 (SPD)

Prosurge T3 Surge Protection Device (SPD) is designed for low-voltage power supply system protection against surges at the boundaries from lightning protection zone 2-3 and higher.

Rhaid eu gosod mor agos â phosibl o'r cyfarpar sensitif i'w amddiffyn. Wedi'u profi gyda generadur tonnau cyfuniad cyfredol 1,2 / 50 - 8/20, maent yn sicrhau gwerth foltedd lefel amddiffyn isel iawn.

• Comply with IEC 61643-11 and UL1449 5th
• Dyluniad parod, wedi'i ddisodli'n hawdd heb unrhyw offer.
• High Discharge Capacity with 8/20 us waveform, Imax 10kA to 25kA 8/20
• Dibynadwyedd uchel oherwydd dyfais datgysylltu thermol
• Dangosydd statws gweledol a chysylltiad signal o bell ar gael
• Mono block type for single phase and three phase configuration are available

SPD Mowntio PCB - Gellir ei blygio wrth ei osod gyda soced sodro

The PCB mounting surge protective device is easy untegrated in PCB and close to sensitive electronic element inside device, to minimize the potential impact of lightning events. The PCB mounting SPD will help to significantly reduce the cost of substantial repair, replacement, system downtime and the loss of revenue.

SPD mowntio PCB Prosurge yw optimeiddio maint ac effeithlonrwydd gofod, sy'n ddatrysiad perfformiad uchel ond cost isel ar gyfer y diwydiant electroneg pŵer. Mae'n cyflogi Varistor Metel Ocsid (MOV) ynni uchel, ac wedi'i adeiladu gyda diogelwch thermol patent a thechnoleg diffodd arc sy'n sicrhau datgysylltu diogel tra bod cerrynt diffygiol neu foltedd annormal yn digwydd. Mae SPDs mowntio PCB Prosurge wedi gwella'r perfformiad diogelwch yn gynhwysfawr ac wedi profi i fod yn ddyfeisiadau amddiffynnol ardderchog sy'n methu'n ddiogel ac yn hunan-amddiffyn oherwydd technoleg patent.

• Rating:
  • Ar gyfer cais AC: Max. Foltedd gweithredu parhaus (MCOV): 75 ~ 750Vac
  • Ar gyfer cais DC/PV: Max. Foltedd DC a Ganiateir (Vpvdc): 48-825Vdc
  • Capasiti ymchwydd (8/20 μs): 50kA ~ 80kA
  • Cerrynt impulse (10/350 μs): 7.5kA ~ 12.5kA
  • SCCR(UL1449 5th)：up to 200kA – tested without external CB or fuse
  • Iscpv (IEC61643-31)：1000A

• Cydnabu UL SPD Math 1ca (ANSI / UL1449 5th), Math 2ca SPD (CSA-C22.2 )
• TUV ardystiedig yn unol â safon IEC 61643-31
• Ymateb thermol cyflym a swyddogaeth dorri cylched perffaith oherwydd dyluniad datgysylltu thermol arbennig gyda dyfais diffodd arc
• Amrediad tymheredd gweithredu eang a dibynadwyedd uchel
• Cynhwysedd presennol uchel a gollyngiad isel ar hyn o bryd
• Cyswllt signalau anghysbell ar wahân ar gyfer arwyddion bai tra defnyddiau ychwanegol o PVD_Base

Ar gyfer marchnad Gogledd America, cysylltwch â

[e-bost wedi'i warchod]

+ 86 757 8632 7660

Ar gyfer marchnadoedd eraill, cysylltwch â

[e-bost wedi'i warchod]

+ 86 757 8632 7660

Cliciwch i wirio ein rhwydwaith gwerthu byd-eang